Pump Technical Treatment And Common Troubleshooting

Jul 30, 2024 Leave a message

One: Vibration occurs during operation
1. Pipe support is unstable and the bolts on the pump base or anchor are loose, which is a common cause of vibration. Tighten the bolts to prevent loosening.
2. If there is gas in the liquid, carefully check whether the sealing bolts of the water pump and the water inlet pipe are loose, whether the sealing gasket is damaged, and whether the pump body and the parts of the pipeline system are damaged.
3, the pump and the motor shaft is different, should be adjusted, with the belt rotation, the rotation belt is too loose or the joint contact is poor, will also cause vibration. Multistage centrifugal pump manufacturers pump impeller unbalanced operation impeller wear or individual impeller channel blockage easy to cause vibration, and sometimes due to shaft bending impeller bad loss of balance caused by vibration.
Two: Noise increases during operation
1. Bearing noise: the bearing installation part of the sound source, generally with an iron rod or screwdriver against the bearing installation part, with the ear, for the clatter.
Motor noise: generally howling sound, can only replace the motor.
Cavitation noise: The sound source is in the pump chamber, crackling sound. Three. Motor hot China pump technology forum
The outer wall of the motor is hot, it may be overcurrent operation, you can turn off the outlet valve and adjust it to the rated current operation, it may also be the quality problem of the motor coil, which can only replace the motor.
2. Friction occurs in rotating parts, friction resistance increases, and the motor may be hot due to overcurrent. Stop the machine to check whether the rotor is flexible.
The motor bearing is hot, the bearing may lack of oil or damage, need to be repaired or replaced.
The operating voltage is too low, check the circuit adjustment voltage.
No water after starting: there is air in the pump or gas in the inlet pipe, or the bottom valve is not tightly closed, the vacuum pump packing is seriously leaking, and the gate valve or the tap door is not tightly closed.
Removal: Remove debris, replace the damaged rubber pad, change the direction of the valve disc; Press or replace the new packing, close the gate valve or slap the door; Increase the amount of injection until the bleed plug is not bubbling; Replace cracked pipes; Lower the head and press the nozzle of the pump into the water 0.5 meters.
When starting the pump does not turn: the packing is too tight or between the impeller and the pump body is blocked by debris, or the pump shaft, bearing, leakage reduction ring rust, or the pump shaft is seriously bent.
Elimination: relax the packing, dredge the channel; Disassemble the pump body to remove debris and rust; Remove pump shaft to correct or replace with new pump shaft.
Pump heating bearing damage: rolling bearing or bracket cover clearance is too small; The pump shaft is bent or the two shafts are different; The tape is too tight; Lack of oil or poor oil quality; The balance hole on the impeller is blocked, and the impeller is out of balance, increasing the thrust to one side.
Exclusion: replacement of bearings; Remove the back cover and install a gasket between the bracket and the bearing seat; Adjust the pump shaft or adjust the concentricity of the two axes; Adjust the tightness of the tape properly; Add clean butter, butter accounted for 60% of the bearing space; Remove the blockage in the balance hole.
Insufficient flow after starting: the speed is not matched or the belt slips, making the speed low; Axial flow pump blade installation Angle is too small; Insufficient head; High suction; Local blockage of the bottom valve, pipeline and impeller or impeller defect; The outlet pipe is leaking badly.
Elimination: restore rated speed, remove belt grease, adjust belt tightness; Adjust the blade Angle and lower the installation position of the water pump; Seal the leak of the pump, press the packing; Remove the blockage and replace the impeller; Replace the leak reducing ring and plug the leak.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry